Distance relay protection study using etap software at the Langsa substation on 150 kV transmission line

Banua Riansyah Piqri Rambe
Electrical Engineering, Malikussaleh Unversity, Indonesia
Arnawan Hasibuan
Electrical Engineering, Malikussaleh Unversity, Indonesia
Ratih Mar'atus Sholihah
Electrical Engineering, Universitas Tadulako, Indonesia
Ahmad Zaidi
Electrical Engineering Technology, Universiti Malaysia Perlis, Malaysia

Abstract


The reliability of an electric power system is strongly influenced by the ability of its protection system to detect and isolate faults quickly, selectively, and reliably. One of the protection devices used on transmission lines is the distance relay, which operates based on the measurement of impedance between the relay location and the fault point. This study aims to evaluate the suitability of distance relay settings on the 150 kV Langsa Substation–Tualang Cut Substation transmission line and to analyze coordination among protection zones using Electrical Transient Analysis Program (ETAP) software. The study was conducted by comparing the existing relay settings with theoretical calculation results and three-phase fault simulation results. The research objects consisted of Tualang Cut 1, with a line length of 22.1 km, and Tualang Cut 2, with a length of 88.7 km. The results show that the existing settings for Tualang Cut 1 remain relatively suitable. However, Tualang Cut 2 exhibited underreach conditions of 21.7% in Zone 1, 32.6% in Zone 2, and 83.6% in Zone 3. Based on the evaluation results, new settings of 15.8 Ω for Zone 1, 23.7 Ω for Zone 2, and 43.4 Ω for Zone 3 are recommended. Simulation results indicate that the recommended settings provide graded protection coordination.

Keywords


Distance Relay; Protection System; 150 kV Transmission; ETAP; Protection Coordination.

Full Text:

PDF

References


M. J. Ashari, “The impact of biogas power plant penetration on power system stability in the 20 kV distribution network of Tanjung Pura,” J. Geuthee Eng. Energy, vol. 4, no. 1, pp. 34–48, 2025, doi: 10.52626/joge.v4i1.49.

A. A. Y. Tayeb and S. B. Utomo, “Analysis of Distance Relay Settings and Coordination After Reconductoring SUTT 150 kV Babat-Lamongan,” J. Tek. Elektro dan Komputasi, vol. 8, no. 1, pp. 129–138, 2026, doi: 10.32528/elkom.v8i1.5290.

I. H. Muchmad Jafar Shodik, “Evaluation of Distance Relay Setting Values for 150 kV High-Voltage Overhead Line Protection Using DIgSILENT PowerFactory,” vol. 14, no. 1, pp. 1–13, 2024, [Online]. Available: https://doi.org/10.33322/sutet.v14i1.2291

M. N. Ulum and S. B. Utomo, “Analysis of Distance Relay Coordination Setting in 150 kV Transmission Line Protection System PLTMG BAUBAU Substation - BAUBAU Substation - RAHA Substation,” Eduvest - J. Univers. Stud., vol. 6, no. 1, pp. 1125–1133, 2026, doi: 10.59188/eduvest.v6i1.52129.

H. S. Adi and A. B. Muljono, “Analysis of Transmission Line Protection Testing Using a Distance Relay at the Sengkol–Kuta Line Bay of Sengkol 150 kV Substation,” J. Inform. dan Tek. Elektro Terap., vol. 13, no. 3, 2023.

M. F. P. Utami, Y. Volta, “Simulation Of Electric Power System Protection Coordination Using Etap,” Med. Trada J. Tek. Elektromedik Polbitrada, vol. 5, no. 1, pp. 25–34, 2024.

Z. Xie et al., “Error analysis and improved method of time-domain distance protection for wind power transmission lines,” Int. J. Electr. Power Energy Syst., vol. 160, no. February, p. 110081, 2024, doi: 10.1016/j.ijepes.2024.110081.

Y. Simamora, M. S. Dewy, and A. I. Silitonga, “Analysis of Overcurrent Relay Coordination in the Jelok Hydroelectric Power Plant Protection System for the Electric Power System Protection Course,” J. Teknol. Inf. Komun. Dalam Pendidik., vol. 11, no. 1, 2024, doi: 10.24114/jtikp.v11i1.60288.

Reza Sarwo Widagdo, G. Budiono, Aris Heri Andriawan, Puji Slamet, and R. W. Putra, “Analysis of Fault Locations Using the Impedance Method on the GIS 150 kV Transmission Line Karang Pilang Surabaya,” J. Poli-Teknologi, vol. 23, no. 2, pp. 83–92, 2024, doi: 10.32722/pt.v23i2.6837.

N. N. Fitrah, M. Syukri, A. Info, and G. Hubung, “Seimbang Pada Jaringan Distribusi Sistem Radial Feeder Lk 07 Sistem Kelistrikan,” vol. 1, no. 1, pp. 12–20, 2022.

R. H. Siregar, A. Farras, and S. Syahrizal, “Short circuit current limitation using series reactors in 20 kV distribution feeder,” J. Geuthee Eng. Energy, vol. 5, no. 1, pp. 62–74, 2026, doi: 10.52626/joge.v5i1.94.

D. Romdhani, Supriyatna, and A. B. Muljono, “Distance relay protection on high voltage transmission line 150 kV from Ampenan Substation to Lombok Energy Dynamic steam power plant,” Dielektrika, vol. 8, no. 1, pp. 36–43, Feb. 2021, doi: 10.29303/dielektrika.v8i1.263.

I. F. Pasaribu and D. Fauziah, “Analysis of Distance Relay Settings on the 150 kV Bay 1 Kiaracondong–South Bandung Substation Transmission Line,” Pros. Disem. FTI Gen. 2021/2022, pp. 1–9, 2021.

D. Aminarti, “Analysis of Distance Relay Settings for the 150 kV Sunyaragi Substation Transmission Line,” vol. 3, no. 2, pp. 58–63, 2025.

J. Arifin, H. Yamashika, and A. Dwiharzandis, “Comparison of Fault Location Determination Between a Fault Locator and Distance Relay on the 150 kV Teluk Kuantan Line,” vol. 9, no. 2, pp. 182–184, 2026.




DOI: https://doi.org/10.52626/joge.v5i2.104

Refbacks

  • There are currently no refbacks.


Journal Geuthee of Engineering and Energy is published by Geuthee Institute.
St. Teknik II, Reumpet, Krueng Barona Jaya sub-district (23370), Aceh Besar District, Aceh Province, Indonesia.
http://geutheeinstitute.com/
ISSN (Online): 2964-2655
E-mail: journal.joge@gmail.com 
The published content of this journal is licensed under a Creative Commons Attribution 4.0 International License.